|
|
| 1/48 F-16B J79 (3D Printed parts included) |
|
|

|
| Manufacturer |
KINETIC |
| Item No |
KI-K48195 |
| Scale |
1/48 |
|
Product Description
The F-16/79 (often referred to as the F-16/J79) was a deliberately downgraded, low-cost export variant of the General Dynamics F-16 Fighting Falcon developed in the late 1970s. It was modified to run on an older General Electric J79 turbojet engine instead of the standard, more advanced Pratt & Whitney F100 turbofan engine
The aircraft was created in response to President Jimmy Carter's 1977 arms export policy. This directive barred the sale of top-tier, front-line U.S. fighters (like the standard F-16A) to foreign nations to prevent regional arms races and protect sensitive technology.
The U.S. government established the "FX" program, prompting General Dynamics to privately fund the development of a less capable F-16 that would meet these strict export limitations while competing against Northrop's F-20 Tigershark.
Key Design Modifications
Fitting a J79 turbojet into a frame built for an F100 turbofan required significant engineering changes:
. Airframe Changes: The rear fuselage had to be stretched by 18 inches to accommodate the longer engine.
. Intake Re-design: The aircraft's signature smile-shaped air intake had to be structurally altered to change air pressure and flow for the turbojet.
. Thermal Shielding: Because the older J79 engine ran significantly hotter than the F100, engineers had to add a heavy steel heat shield around the engine compartment.
. Weight Penalties: These modifications added roughly 2,000 pounds (one ton) of dead weight to the airframe
Model Features: 1. 3D Printed J79 engine nozzle 2..3D Printed updated INTAKE
|